Sears 502493 Chipper User Manual


  Open as PDF
of 28
 
15
FOR 1990 AND NEWER MURRAY
TRACTORS WITH A 38" OR 40" DECK
1. Cut out two templates and place on deck adapter as
showningure29.Tapesmalleroneontopandlarger
one on the side and bottom. After they are in place,
carefully mark around the templates, then cut out
adapter to obtain correct opening.
2. Bolt end of mounting strap to the 5/16" bolt on the
mower deck. The other end of the strap will bolt to
a hole in the deck adapter, which must be drilled.
Position the adapter on the deck, then drill a 5/16"
hole in the bottom of the adapter that will align with
the hole in the strap. Fasten the adapter to the strap
usinga1/4"x3/4"hexbolt,1/4"atwasher,nylon
washerand1/4"nylocknut.Seegure29.
3. Assemble end of hose and hose clamp over the round
opening of deck adapter and tighten clamp.
GO DIRECTLY TO THE OPERATION INSTRUCTIONS
WHICH ARE LOCATED ON PAGE 16.
FIGURE 29
GO DIRECTLY TO THE OPERATION INSTRUCTIONS
WHICH ARE LOCATED ON PAGE 16.
1. Tape 46" template onto deck adapter. Mark and then
cut out adapter .
2. Fasten the angle bracket and the mounting bracket to
themowerdeckasshowningure30.Usetwo5/16"
x3/4"carriagebolts,5/16"atwashersand5/16"lock
nuts. The bolt heads go on inside of mower deck.
3. Drill two 5/16" diameter holes in the deck adapter
that will align with the holes in the angle bracket and
the mounting bracket. Assemble the deck adapter to
bothbracketsusingtwo1/4"x3/4"hexbolts,1/4"at
washers, nylon washers and 1/4" nylock nuts. See
gure30.
4. Assemble end of hose and hose clamp over the round
opening of deck adapter and tighten clamp.
FIGURE 30
FOR 1990 AND NEWER MURRAY
TRACTORS WITH A 46" DECK
ANGLE BRACKET
NYLON WASHER
LOCATE AND
DRILL HOLES
1/4" x 3/4"
HEX BOLT
1/4" x 3/4" HEX BOLT
NYLON WASHER
1/4" FLAT WASHER
NYLON WASHER
1/4" FLAT WASHER
MOUNTING
BRACKET
MOUNTING
BRACKET
1/4" FLAT
WASHER
1/4" FLAT
WASHER
1/4" NYLOCK NUT
1/4" x 3/4" HEX BOLT
1/4" FLAT WASHER
NYLON WASHER
1/4" NYLOCK NUT
MOUNTING STRAP
BOLT THIS END OF
STRAP TO 5/16" BOLT
ON MOWER DECK
38"/40" TEMPLATE
CUT OUT SLOT IN TOP
OF DECK ADAPTER
TEMPLATE TO CUT OUT SLOT
 previous next