Filter
Top Products
SERVICE AND ADJUSTMENT
HOW TO SET THE HEIGHT OF CUT
The height of cut is sat at the factory from 1'/_ to 4inches To lower
or raise the height of cut make an adjustment to the lifter rod
as follows
1 Move the lift lever to the LOW cut position
2 Disconnect the lifter rod from the lifter arm
3 Turn the lifter rod clockwise to lower or counterclockwise to
raise the height of cut
4 Attach the lifter rod to the lifter arm
5 Move the lift lever to the HIGH position Make sure the
pulleys or belt do not touch the bottom of the frame
HOW TO START WITH A WEAK BATTERY
Ifthebatteryistooweaktostarttheengine thebatteryneedstobe
charged If "Jumper Cables" are used to start the engine in an
emergency folfowthe procedure below
NOTE: The unit is equipped with a 12 volt negative to ground
system Also, the other vehicle must have a 12 volt negative to
ground system
WARNING: Do not smoke The fumes from the
battery acid can cause an explosion Keep the
battery away from any flames or sparks To
prevent sparks, fasten the red jumper cable to
the positive (+) terminal before connecting the
black jumper cable
1 Put a wet cloth over the vent caps of each battery
2 Connect each end of the RED'Jumper Cable" to the positive (+)
terminais of each battery Make sure you do not touch the
chassis with the cables
3 Connect one end of the BLACK ",Jumper Cable" to the
negative (--) terminal of the charged battery
4 Connect the other end of the BLACK "Jumper Cable" to the
engine block
5 Start the engine that has the weak battery last Allow the
engine to run
6 To disconnect the "Jumper Cables" reverse the above steps
Hair Pin
HOW TO CLEAN THE MOWER HOUSING
_ WARNING: Before you clean the mower hous-
ing, stop the engine and disconnect the wire to
the spark plug
Grass and other debris on top of the mower housing can keep the
belt from working correctly Clean the mower housing as follows
1
2
3
4
5
F-92533
Move the lever for the blade engagement control to the
ENGAGE position
Clean the top of the mower housing
Move the lever for the blade engagement control to the
DISENGAGE position
Again clean the top of the mower housing
After you cut the grass, clean the bottom of the mower
housing 29
HOW TO REPLACE THE FUSE
If the fuse is blown the enginewitlnot start Thelocationofthe fuse
is next to the battery Remove the fuse and replace with a
15 amp Automotive fuse
FRONT WHEEL ALIGNMENT
The alignment of the front wheels cannot be adjusted If the
steering is damaged and the alignment has changed see your
nearest Sears Service Center