Filter
Top Products
4
ASSEMBLY INSTRUCTIONS
FIGURE 2
TOOLS REQUIRED FOR ASSEMBLY
(2) 1/2" Wrenches
(1) Screwdriver
(1) Pliers
FIGURE 1
1. Remove all items from carton and lay out as shown on
pages 2 and 3.
2. Assemble the axle clamps, axle support tube and four
5/16" SEMS nuts to the factory installed bolts in the
frame tubes. See gure 1.
5. Fasten the front ends of the frame tubes together using
two 5/16" x 3" hex bolts and 5/16" nylock nuts. Do not
tighten yet. See gure 3.
6. Assemble hitch brackets to frame tubes using two 5/16"
x 2-1/4" hex bolts, four washers (one on each side) and
5/16" nylock nuts. Position each bolt behind a cross bolt
in the hitch arms. Do not tighten yet. See gure 3.
7. Tighten bolts assembled in step 7 then tighten bolts
assembled in step 8. See gure 3.
FIGURE 3
3. Slide the axle through the axle support tube. See
gure 2.
4. Assemble a 3/4" washer, a wheel (valve stem facing
out) and another 3/4" washer onto the axle. Assemble
a cotter pin through the end of the axle. Repeat on other
end. See gure 2.
8. Assemble the boom mount bracket to the rear of the
frame tubes using two 5/16" x 2" hex bolts and 5/16"
nylock nuts. See gure 4.
FIGURE 4 REAR VIEW
FACTORY
INSTALLED
BOLT
AXLE
CLAMP
AXLE
SUPPORT
TUBE
5/16" SEMS NUT
3/4" WASHER
AXLE
AXLE
SUPPORT
TUBE
1/8" x 1-1/2"
COTTER PIN
5/16" x 2-1/4"
HEX BOLT
5/16" NYLOCK NUT
5/16" x 3"
HEX BOLT
5/16" WASHER
5/16" WASHER
5/16" NYLOCK NUT
5/16" NYLOCK NUT
5/16" x 2"
HEX BOLT