Filter
Top Products
24
R
Section 6
Rotate the cutter blade on the right side of the cutter 6.
deck. Position the cutter blade so it is facing "front to
back" on the machine.
Check the measurement from the floor to the cutter
7.
blade tip at the front and rear of the right side blade.
If the measurement is not at 3", an adjustment must
be made using the cutter deck adjustment lever.
Adjust as follows:
A. Loosen the elastic stop nuts securing the deck level
links on front of the cutter deck on both sides (See
Figure 6-4 and Figure 6-5 for Cutter Deck Adjustment
Lever Location).
B.Turn the adjustment bolts on both side either
clockwise to raise or counterclockwise to lower the
cutter deck until the measurements are equal. Tighten
the elastic stop nuts.
CUSTOM-CUT BAFFLE ADJUSTMENT
The Custom-Cut Baffle is designed to deliver optimum
airflow and superior cutting performance in any type of
grass. The Custom-Cut Baffle can be raised or lowered
to precisely tailor the deck's performance for the type of
grass being cut. The baffle can be set in seven (7) different
positions for optimum performance.
A. 3-1/2" or 3-3/4" Position - See Figure 6-7. For very
tall, wiry or tough-to-cut grass.
B. 4" (factory setting), 4-1/4" or 4-1/2" Position - See
Figure 6-7. For general purpose cutting. This gives the
best mix of cutting performance in all types of grass.
C. 4-3/4" or 5-1/4" Position - See Figure 6-7. Placing
the baffle in either the 4-3/4" or 5-1/4" setting will
enhance fall cutting (leaf pickup) and reduce cutter
deck "blowout".
To adjust the Custom-Cut Baffle height:
Park the machine on a flat surface, apply the parking 1.
brake, shut off the engine and remove the key.
Place the cutter deck in the transport position.2.
Remove the hardware securing the Custom-Cut 3.
Baffle to the cutter deck.
- NOTE -
Hardware location used in the illustrations are for
reference only. Location of hardware may vary
depending on cutter deck size.
Move the Custom-Cut Baffle to desired position. See
4.
Figures 6-7.
Reinstall the mounting hardware. Torque hardware to
5.
39 ft-lbs.