Filter
Top Products
39
R
Section 7
B. CHANGING LUBRICANT
The lubricant in the cutter deck gearbox should be
changed after every 500 hours of operation or yearly,
whichever occurs first.
Place a suitable container beneath the cutter deck
1.
gearbox and locate the gearbox drain plug.
Remove the drain plug, drain the lubricant into the
2.
container and properly discard it.
Re-install the drain plug and add SAE 80W90 3.
lubricant through the check plug hole in the gearbox
until it is level with the bottom of the check plug hole.
Install the check plug and tighten securely.
BODY, DECK, AND UPHOLSTERY7.12
CAUTION
Do not wash any portion of the equipment while it
is hot. Do not wash the engine; use compressed
air.
After each use, wash the mower and cutter deck. 1.
Use cold water and automotive cleaners. Do not use
pressure cleaners.
Do not spray electrical components.2.
Use a mild soap solution or a vinyl/rubber cleaner to 3.
clean the seat.
Repair damaged metal surfaces using Scag touch-4.
up paint available from your authorized Scag dealer.
Wax the mower for maximum paint protection.