Filter
Top Products
Section 6
27
To adjust the Custom-Cut Baffle height:
1. Place the cutter deck in the transport position.
2. Remove the hardware securing the Custom-Cut
Baffle to the cutter deck. (See Figure 6.8).
-NOTE-
Hardware location used in the illustrations are
for reference only. Location of hardware may
vary depending on cutter deck size.
Figure 6-8. Custom-Cut Baffle
3. Move the Custom-Cut Baffle to desired position.
(See Figures 6.9 through 6.11 for position).
4. Reinstall the mounting hardware as shown. (See
Figures 6.9 though 6.11). Torque hardware to 39 ft/
lbs.
Figure 6-11. 4" Custom-Cut Baffle Position
Figure 6-10. 3-1/2" Custom-Cut Baffle Position
2004 CCB
MOUNTING
HARDWARE
MOUNTING
HARDWARE
2004 CCB - 3" Setting
CARRIAGE BOLT
TOP SET OF HOLES
FOR 3" SETTING
FLATWASHER
ELASTIC STOP
NUT
2004 CCB - 3-1/2" Setting
CARRIAGE BOLT
MIDDLE SET OF HOLES
FOR 3-1/2" SETTING
FLATWASHER
ELASTIC STOP
NUT
2004 CCB - 4" Setting
CARRIAGE BOLT
BOTTOM SET OF HOLES
FOR 4" SETTING
FLATWASHER
ELASTIC STOP
NUT
C. 4" Position (factory setting) - baffle is installed using
the bottom set of holes on the front baffle welded
inside the cutter deck. (See Figure 6.11). Placing the
baffle in the 4" setting will enhance fall cutting (leaf
pickup) and reduce cutter deck "blowout".
Figure 6-9. 3" Custom-Cut Baffle Position
A. 3" Position - baffle is installed using the top set of
holes on the front baffle welded inside the cutter
deck. (See Figure 6.9). In this position the Velocity-
Plus cutter deck will deliver the best quality-of-cut in
very tall, wiry, tough to cut grass.
B. 3-1/2" Position - baffle is installed using the middle
set of holes on the front baffle welded inside the
cutter deck. (See Figure 6.10). Can be used for
general purpose cutting. Placing the Custom-Cut
Baffle in the 3-1/2" position gives a good mix of
cutting performance in all types of grass.