Filter
Top Products
5
1. Prepare the work area making sure that it is a
clean, safe environment.
2. Remove the bag assemblies from the grass
catcher.
3. Remove the rubber strap holding the adapter to
the blower assembly. See Figure 6.
4. Remove the pin holding the blower assembly to
the mounting bracket on the cutter deck and
remove the blower assembly. See Figure 6.
Figure 6
5. Remove the two (2) pins holding the hood
assembly to the mounting posts on the rear of the
machine. See Figure 7.
Figure 7
4.1 GRASS CATCHER REMOVAL
INSTRUCTIONS
6. Remove the hood assembly.
7. Re-install the side discharge chute to the opening
on the cutter deck. Replace the two outside
mounting bolts on the discharge chute with the
clevis pins (p/n 04064-15) and rue cotter pins
(p/n 04069-03). See Figure 8.
Figure 8
BLOWER
ASSEMBLY
MOUNTING
BRACKET
PIN
ADAPTER
RIGHT SIDE OF
CUTTER DECK SHOWN
(Note: Some parts not shown for viewing purposes.)
GC-STC removal art 1
GC-STC removal art 2-A
REMOVE
MOUNTING
PINS
CLEVIS PIN
P/N 04064-15
CLEVIS PIN
P/N 04064-15
RUE COTTER PIN
P/N 04069-03
DISCHARGE
CHUTE
GC-STC removal art 3
WARNING
WARNING
DO NOT OPERATE WITHOUT DISCHARGE CHUTE, MULCHING
KIT, OR ENTIRE GRASS CATCHER INSTALLED