Filter
Top Products
53 29 271 7
Saab 9-5 B205, B235
18 If necessary, disconnect the cable to the lower
oxygen sensor and remove the frost plug using
tool 260 147 020. Use, for example, a 17 mm
socket.
19 Apply acid-free petroleum jelly, part no. 30 06
665, or equivalent, to the heating element O-
ring.
20 Fit the heating element so that the electrical
connection is directed towards the left-hand side
of the car and the connection is between the
coolant pipes and under the turbocharger cool-
ant pipe. Do not tighten the nut holding the heat-
ing element.
21 Adjust the position of the heating element so
that it is free from contact with the coolant pipes.
Tighten the nut.
Tightening torque 3.5 Nm (2.5 lbf ft)
Connect and secure the cable to the lower oxy-
gen sensor.
22 Apply acid-free petroleum jelly, part no. 30 15
286 or equivalent, to the O-ring on the supply
connector cable and connect the cable to the
heating element.
23 Fit the lock clip over the connection. A click
should be heard when the lock clip is fitted cor-
rectly.
24 Aut: Secure the supply connector cable to the
lower cable by the battery tray with the clips
included in the kit.
Man: Secure the supply connector cable to the
left-hand structural member with a strap.
E930A397
18
23
20
WARNING
Make sure that the cable does not make contact
with sharp edges or hot surfaces. Be aware of the
turbo unit. Scrapes and heat damage can cause a
short-circuit.