Filter
Top Products
19
UK
GUARANTEE – STATEMENT
(RTSA / RTUK / RTG)
All Ryobi products are guaranteed from defects in material and workmanship, for a period of twenty-four (24) months, effective
and evidenced from date of original invoice or delivery note.
Defects caused by normal wear and tear, unauthorised/improper maintenance/handling or overload are excluded from this
guarantee as are accessories such as battery packs, bulbs, blades and bits, etc.
In the event of malfunction within the guarantee period, please return the assembled product with proof of purchase to your
dealer or nearest Ryobi Service Centre.
Your statutory rights in respect of defective products remain unaffected by the warranty.
Ryobi Technologies GmbH, Itterpark 7, D-40724 Hilden, Germany
Ryobi Technologies, Customer Services, Anvil House, Tuns Lane, Henley-on-Thames, RG9 1SA, UK
Ryobi Technologies, BP 50012 - 95945 Roissy CDG Cedex – FRANCE
Ryobi Technologies Australia PTY Limited, 359-361 Horsley Road, Milperra, NSW 2214 Australia
WARRANTY
PROBLEM POSSIBLE CAUSE SOLUTION
Engine starts, runs,
and accelerates but will
not idle.
Engine starts and runs,
but chain is not rotating.
Bar and chain running hot
and smoking.
Carburettor requires adjustment.
1. Chain oil tank empty.
2. Check chain tension for overtight
condition.
3. Check for oiler function.
1. Chain brake engaged.
2. Chain tension too tight.
3. Check guide bar and chain
assembly.
4. Check guide bar and chain for
damage.
Turn idling speed screw “T” clockwise to increase idling
speed. If chain turns at idle, turn idling speed screw “T”
anticlockwise to decrease speed. Wear protective
equipment and observe all safety instructions.
See
Figure 24.
1. Oil tank should be filled every time fuel tank
is filled.
2. Tension chain per instructions in “Maintenance –
Adjusting the Chain Tension” earlier in this manual.
3. Run at half throttle 30 to 45 seconds. Stop saw and
check for oil dripping from SAFE-T-TIP® and guide bar.
If oil is present the chain may be dull or bar may be
damaged. If no oil is on the SAFE-T-TIP®, contact a
Ryobi service dealer.
1. Release chain brake, refer to “Operation – Operating
Chain Brake” earlier in this manual.
2. Tension chain per instructions in “Maintenance –
Adjusting the Chain Tension” earlier in this manual.
3. Refer to “Maintenance – Assembling the Bar and
Chain” earlier in this manual.
4. Inspect guide bar and chain for damage.
NOTE: The carburettor adjustment needle(s) are equipped with plastic cap(s) that prevent anticlockwise rotation from the original
factory adjustment. If your product exhibits specific performance problem(s) where the Troubleshooting Section recommends an
anticlockwise needle adjustment and you have made no adjustments since the original purchase, take the product to a factory
authorised service dealer for repair. In most cases, the needed adjustment is a simple task for the factory trained service
representative.
TROUBLESHOOTING