Filter
Top Products
7
ASSEMBLY
GRASS DEFLECTOR
BRACKET
BOLT
FLAT WASHER
LOCK WASHER
WING NUT
Fig. 2
ASSEMBLY INSTRUCTIONS:
GRASS DEFLECTOR
See Figure 2.
1. Remove wing nut, flat washer, lock washer and bolt
from the Owner’s Kit.
2. Place grass deflector over shaft and bracket.
3. Install bolt through the slots in the tabs on grass
deflector and bracket on drive shaft housing.
4. Install flat washer, lock washer and wing nut.
5. Tighten securely.
FRONT HANDLE
See Figure 3.
1. Remove the front handle, bolt and wing nut from the
Owner’s Kit.
2. Install the front handle onto the top side of the drive
shaft housing and move it to a comfortable position.
3. Place the bolt through the front handle as shown.
Then install the wing nut.
4. Tighten the wing nut securely.
NOTE: Do not attempt to remove or modify the spacer.
This spacer limits the upper position of the handle grip.
See Figure 3.
WING NUT
FRONT HANDLE
BOLT
Fig. 3