Filter
Top Products
10
ASSEMBLY
ATTACHING THE RESTING FOOT
See Figure 3.
Lift the machine slightly. Slide the resting foot into the
bottom of the spray wand storage tube.
Push the resting foot into the storage tube until the base
of the machine rests in the grooves on top of the resting
foot.
ASSEMBLING THE SPRAY WAND
See Figure 4.
To attach the assist handle assembly:
Remove the wing screw from the assist handle assembly
then slide the spray wand assembly onto the assist handle
assembly bracket.
NOTE: The smooth side of the assist handle assembly
can be facing down or up.
Position the assist handle between the ribs of the spray
wand aligning the tab and the detent.
Secure the assist handle in place by tightening the wing
screw.
To attach the spray wand extension:
Place the threaded end of the wand extension in the
connector on the end of the spray wand assembly. Push
until it snaps into place.
Turn the connector clockwise until it stops. This secures
the wand extension in place.
When not in use, place the assembled spray wand into
the spray wand storage.
CONNECTING HIGH PRESSURE HOSE TO
SPRAY WAND ASSEMBLY
See Figure 5.
Uncoil the high pressure hose.
Pull back and hold the quick-connect collar on the high
pressure hose.
Insert the inlet coupler on the spray wand handle into the
collar.
Release the collar and push until it clicks.
Pull on the hose to be certain it is properly secured.
ATTACHING INJECTION HOSE
See Figure 6.
Before detergent can be used with this machine, the
injection hose must be attached.
Uncoil the clear injection hose.
Push the open end of the injection hose securely over
the barbed fitting.
Lift the chemical bucket and push the injection hose into
the slot on the back of the bucket.
Replace the bucket in the bucket holder.
Fig. 4
Fig. 5
qUICK-
COnneCt
COllAr
HIgH
PressUre
HOse
Inlet
COUPler
AssIst
HAnDle
AsseMBlY
sPrAY
WAnD
eXtensIOn
COnneCtOr
sPrAY
WAnD
restIng
fOOt
Fig. 3
rIBs
tAB
Detent