Ryobi Outdoor CS30 ZR30000 Trimmer User Manual


 
Page 12
ASSEMBLY
ATTACHING THE GRASS DEFLECTOR
WARNING:
The line cutting blade on the grass deflector is sharp.
Avoid contact with the blade. Failure to avoid contact
can result in serious personal injury.
TO ATTACH THE CURVED SHAFT GRASS DEFLECTOR
- ZR30000
See Figure 6.
1. Press the grass deflector onto the bottom of the curved
shaft as shown.
2. Insert the hex head cap screw through the grass deflec-
tor and the bracket on the curved shaft.
3. Place the flat washer and lock washer on the hex head
cap screw.
4. Place the wing nut on the hex head cap screw and
tighten securely.
TO ATTACH THE STRAIGHT SHAFT GRASS DEFLEC-
TOR - ZR30002
See Figure 7.
1. Remove the slotted hex head screw from the grass
deflector.
2. Insert the tab on the mounting bracket in the slot on the
grass deflector.
3. Align the screw hole in the mounting bracket with the
screw hole in the grass deflector.
4. Insert the slotted hex head screw through the mounting
bracket and into the grass deflector.
5. Tighten the screw securely.
ATTACHING THE BRUSHCUTTER GUARD -
ZR30004
See Figure 8.
The guard is shipped installed on these brushcutter models.
Instructions have been included for reference when changing
from string trimmer operation back to brushcutter operation.
1. With the string head removed, place the brushcutter
guard on the gear head as shown.
2. Install the three screws from bottom through the guard
and into the gear head.
3. Tighten the screws securely and torque to 40-50 in.lbs.
minimum (finger right plus 1/4 turn).
GRASS
DEFLECTOR
BRACKET
BOLT
WING NUT
Fig. 6
FLAT
WASHER
LOCK WASHER
Fig. 7
Fig. 8
HEX HEAD
SCREW
STRAIGHT SHAFT
GRASS DEFLECTOR
TAB
SLOT
GEAR HEAD
HEX HEAD
SCREW
BRUSHCUTTER GUARD