Filter
Top Products
11
VAcuum
inleT Door
Door
TAb
INSTALLING THE VACUUM TUBES
See Figures 7 - 8.
WARNING:
Rotating impeller blades can cause severe injury. Always
stop the engine before opening the vacuum door or
installing/changing tubes. Do not put hands or any other
object into the vacuum tubes while they are installed on
the unit.
NOTE: This vacuum/blower is equipped with a vacuum door
interlock. If vacuum door is open and vacuum tubes are not
installed, engine will not start.
To install the vacuum tubes:
Secure the upper and lower vacuum tubes together by
aligning the raised locking tabs with the raised slots.
Tap tube assembly on ground until the screw holes in
lower tube are in the raised slot of the upper tube. Secure
with supplied screws.
Depress door tab and open vacuum inlet door.
Align tabs on housing with tube assembly. Insert tube
assembly into vacuum opening. Twist clockwise and lock
the upper vacuum tube into the blower housing.
Tighten screw on upper vacuum tube to secure to blower
housing.
To remove the vacuum tubes:
Twist to loosen the upper vacuum tube by turning
counterclockwise.
Remove the vacuum tube assembly from the blower
housing.
Close the vacuum inlet cover door securely.
Fig. 8
Fig. 7
VAcuum
openinG
VAcuum Tube
ASSemblY
upper
VAcuum Tube
lockinG TAb
ASSEMBLY
VAcuum
inleT Door
lockinG TAb
VAcuum bAG
ASSemblY
VAcuum
Door hinGe
ScreW