Filter
Top Products
9
Install the cutting attachment shield when using
the unit as a grass trimmer
Install the cutting attachment shield on the shield mount
by inserting the three (3) screws into the shield mount.
Tighten securely with a flat blade screwdriver (Fig. 7).
REMOVE THE CUTTING ATTACHMENT AND
INSTALL THE CUTTING BLADE
NOTE: To make cutting blade removal and installation easier,
place the unit on the ground or on a work bench
.
Remove the Cutting Attachment Shield
See Remove and Install the Cutting Attachment Shield.
Remove the Cutting Attachment
1.
Align the shaft bushing hole with the locking rod slot and
insert the locking rod into the shaft bushing hole (Fig. 8).
Fig. 7
ASSEMBLY INSTRUCTIONS
WARNING: The gear housing gets hot with
use. It can result in injury to the operator.
The housing remains hot for a short time
even after the unit is turned off. Do not
touch the gear housing until it has cooled.
WARNING: To avoid serious personal
injury, the cutting attachment shield MUST
be in place at all times while operating the
unit as a grass trimmer.
2. Hold the locking rod in place by grasping it next to
the boom of the unit (Fig. 9).
3. While holding the locking rod, remove the cutting
attachment by turning it
counterclockwise
off of the output
shaft (Fig. 10). Store the cutting attachment for future use.
Fig. 8
Install the Cutting Blade
4. Place the cutting blade on the output shaft bushing
(Fig. 11).
WARNING: To avoid serious personal
injury, always wear gloves while handling or
installing the blade.
(3) Screws
Cutting
Attachment
Shield
Shield Mount
Shaft
Bushing Hole
Locking Rod Slot
Output Shaft
Bushing
Locking Rod
Output Shaft
Cutting Attachment
Locking
Rod Slot
Locking Rod
Fig. 10
Fig. 9
Shield
Mount
Locking Rod
Cutting
Blade
Blade Retainer
Nut
Output Shaft
Bushing
Pilot Hole
Fig. 11