Ryobi 225RD Trimmer User Manual


 
English – 27
MAINTENANCE
Spark plug
The condition of the spark
plug is affected by:
An incorrect carburettor
setting.
An incorrect fuel mixture
(too much or faulty oil).
A dirty air filter.
These factors cause deposits
on the spark plug electrode
that may result in
malfunction or starting
difficulties.
If the machine is low on power, difficult to start or runs
poorly while idling always check the spark plug first.
If the spark plug is dirty, clean it and at the same time check
that the electrode gap is 0.5 mm. The spark plug should be
changed after about one month of operation or earlier if
necessary.
NOTE! Always use the recommended type of spark plug. An
incorrect spark plug can damage the cylinder/piston.
0,5 mm
Air filter
The air filter should be
cleaned regularly removing
dust and dirt to avoid:
carburettor malfunction
starting problems
reduced engine power
unnecessary wear to
engine parts
abnormal fuel
consumption
Clean the filter after every
25 hours or more regularly
if operating conditions are
exceptionally dusty.
!
WARNING!
Always discard a blade that is bent,
twisted, cracked, shattered or damaged in
any other way. Never attempt to straighten
a twisted blade for use again. Only use
original blades of the prescribed type.
See the cutting
equipment’s packaging
for correct filing
instructions.
The blades are sharpened
using a single cut flat file.
Sharpen all edges equally
to maintain the balance
of the blade.
Filing the grass blade
Angle gear
The angle gear is filled
with a sufficient quantity
of grease at the factory.
However, before using the
machine you should check
that the angle gear is filled
to 3/4 with grease. Use
HUSQVARNA special
grease.
Normally, the grease does
not need to be changed
except when the angle gear
is repaired.
The end of the drive axle in
the lower shaft should be
lubricated with grease every
30 hours. There is a risk that
the drive axle ends (splined
coupling) on two-part shafts
jam if they are not lubricated
regularly.
Two-part shaft
Cleaning the air filter
Dismantle the air filter cover and remove the air filter. Wash in
clean, warm soapy water. Ensure that the filter is dry before
refitting. An air filter used for a long period of time can never
be cleaned completely. Therefore it is necessary to replace the
filter from time to time with a new filter. A damaged air filter
must always be replaced.
!
WARNING!
Always stop the engine before starting
work on any part of the cutting equipment.
This continues to rotate even after the
throttle has been released. Ensure that the
cutting equipment has stopped completely
and remove the cable from the spark plug
before you start to work on it.