Filter
Top Products
118035
Figure 3-6: Removing knob and bolt from handle
Figure 3-7: Placing handle onto shaft
Figure 3-8: Inserting bolt into handle
Figure 3-9: Screwing knob onto bolt
1. Remove the knob and bolt from front
handle (see Figure 3-6).
2. Place the handle on the trimmer/
edger shaft between the rear handle
and the telescope release button. Snap
handle onto shaft (see Figure 3-7).
3. Insert bolt back into the front handle
(see Figure 3-8).
4. Loosely screw knob onto bolt (see
Figure 3-9).
5. Adjust handle to the most comfort
-
able position and tighten the knob
firmly. Do not overtighten the knob.