Remington Power Tools M30016US Chainsaw User Manual


 
21
www.remingtonpowertools.com
ENGLISH
TROUBLESHOOTING
WARNING: Unplug chain saw from power source before servicing. Severe injury
or death could occur from electrical shock or body contact with moving chain.
Note: For additional help, visit DESA Power Tools technical service web site at
www.remingtonpowertools.com.
TECHNICAL SERVICE
You may have further questions about assembling,
operating, or maintaining this product. If so,
you can visit our Technical Service web site at
www.remingtonpowertools.com or contact our
Technical Service Department at 1-800-626-2237
(English Only). You may also write to:
DESA Power Tools
ATTN: Technical Service
P.O. Box 90004
Bowling Green, KY 42102-9004
OBSERVED FAULT POSSIBLE CAUSE REMEDY
Saw runs, but does not
cut
Chain assembled backwards on
guide bar
See Assembly
Saw does not cut unless
heavily forced. Cutting
produces only sawdust
with few large chips
Chain is dull See Sharpening Saw Chain
Saw runs slow. Saw stalls
easily
Low power supply voltage Extension cord wire size too small.
See Extension Cords.
Motor of saw does not
run when you squeeze
trigger
1. Switch lockout not pushed for-
ward in to release trigger
2. Extension cord connections
loose
3. Open line fuse or circuit breaker
4. Worn out motor brushes
5. Open wiring circuit on saw
1. Push switch lockout forward
before squeezing trigger
2. Check cord connections
3. Check line fuse or circuit breaker
4. See authorized service center
5. See authorized service center
Motor of saw runs, but
chain does not move
Gear Sprocket Remove and inspect gear sprocket
for damage
Chain does not get oil 1. Clogged oil slot in guide bar
2. Oil is too thick
1. Remove guide bar and clean oil
slot
2. Use correct weight of oil. See
Filling Oil Tank
Chain comes off guide
bar
1. Chain is loose
2. Guide bar and chain not as-
sembled correctly
1. Tighten chain. See Saw Chain
Tension Adjustment
2. See Assembly
Saw smokes Saw damaged. Do not use saw See authorized service center
Saw leaks oil It is normal for oil to seep when the
saw is not in use.
Tighten oil cap.
Note: Empty oil tank when not
in use.
When contacting DESA Power Tools, have
ready
• Your Name
• Your Address
• Your Phone Number
• Model Number of Product
• Date of Purchase (Include copy of receipt for
written requests).
We reserve the right to amend these specifi cations
at any time without notice. The only warranty
applicable is our standard written warranty. We
make no other warranty expressed or implied.