RedMax SRTZ2460F Trimmer User Manual


 
US-8
SRTZ2460F
6. Set up
MOUNTING ENGINE (SE1)
1. Push the driveshaft housing toward the
clutch housing and rotate it by hand to
check that the driveshaft is engaged
with the gears.
2. Insert the driveshaft housing into the
clutch housing until it bottoms, and
align the positioning holes on the clutch
housing and the shaft tube and install
the screw. When difficult to engage,
twist the engine slightly.
3. Fasten the clamp securely with two
screws.
Tighten the screws gradually by turns.
CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to
the joint on the top of the carburetor.
(SE2)
CONNECTING SWITCH WIRES
Connect the switch wires between the
engine and the main unit. Pair the wires
of the same color.
INSTALLING HANDLE
Mount the handle to the shaft tube and
clamp it at a location that is comfortable
to you. (SE3)
(1) About 19 inches (48cm)
ATTACHING THE TRIMMING
MECHANISM (SE4)
1. Remove the screw screwed into the
end of the trimming mechanism.
2. Insert the end of the trimming
mechanism into the shaft tube.
3. Line up the hole on the end of the
trimming mechanism into which the
screw is to be inserted with the hole on
the shaft tube, and screw the screw
firmly in.
4. Using a wrench, screw in the bolt
provided to fix the trimming mechanism
into place.
(1) Shaft tube
(2) Trimming mechanishm
(3) Screw hole
(4) Bolt
(5) Fastening bolt
IMPORTANT
SE1
SE2
(1)
SE3
(5)
(4)
(3)
(2)
(1)
SE4
BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Depending on the working posture,
slide clamp up or down until unit
balances and the strap fits your body.