RedMax HEZ3001S Edger User Manual


 
36
Maintenance, replacement, or repair of the emission control device and systems may be performed by any
non-road engine repair establishment or individual.
•Always be sure to stop the engine before inspecting the stick edger for problems or performing
maintenance.
•Never alter the stick edger or take the engine apart.
When replacing parts, always be sure to use only RedMax products or products which have been
certified by RedMax for use with the RedMax stick edger.
BE SURE TO CHECK THE FOLLOWING BEFORE USING YOUR STICK EDGER
WARNING
9. Maintenance
English
Item to be checked Response
1 Edging mechanism • See if attachment is loose Tighten screws and bolts
Check if edges of blades are dull Sharpen or replace blades
2 Throttle Stiff and difficult to move Repair or replace
3 Throttle wire Too loose, too tight Adjust
Stiff and difficult to move Repair or replace
4 Engine attachment See if fittings are loose Tighten fittings
5 Fuel tank See if attachment is loose Tighten screws and bolts
See if fuel pipe is damaged Replace
See if cap packing is damaged Replace
6 Muffler See if attachment is loose Tighten screws and bolts
7 Cutting blade • See if damaged or worn shorter than usable Replace
length