Filter
Top Products
❲
20
❳
8. Operation
■ ADJUSTING IDLING SPEED (OP8)
1. When the engine tends stop frequently at idling
mode, turn the adjusting screw clockwise.
2. When the cutting head keeps rotating after
releasing the trigger, turn the adjusting screw
counter-clockwise.
(1) idle adjusting screw
• Warm up the engine before adjusting the idling
speed.
■ HOW TO USE
1 Always wear eye protection such as safety
goggles. Never lean over the rotating cutting
head. Rocks or other debris could be thrown
into eyes and face and cause serious
personal injury.
2 Keep the blade guard and the mad guard
attached in place at all times when the unit is
operated.
3 Before starting a job, check the area and
remove all obstacles and objects that could
be thrown by the blade.
4 Do not adjust the wheel height or try to
remove anything entangled to the blade with
the engine running.
1 Before starting the engine, adjust the wheel
height for desired cutting depth(See page 18).
2 Before starting a job, plan your direction of travel
so that you can always hold the edger on you
right side and can walk on a hard surface as
much as possible.
3 When starting to edge, run the engine at full
throttle, and slowly have the blade cut into the
edge groove.
• Do not use the HEZ2500S to make a new
groove into the ground. Such usage will not
be covered by RedMax Warranty.
NOTE
WARNING
NOTE
(1)
OP8
OP9