Filter
Top Products
22
9. Maintenance
■ BLADE (MA7)
• Place the blade between holders (A) and (B)
while locking the gear shaft by putting the bar,
through the key holes on the holder(A) and the
gearcase. Use the socket and the screwdriver
to tighten the blade mounting bolt.
(1) Blade mounting nut (Left-handed)
Tightning Torque: 130~150in-lbs(15~20N.m.)
(2) Holder (B)
(3) Blade
(4) Holder (A)
(5) Bar
• Attention to the direction of the holder (B)
■ INTAKE AIR COOLING VENT
•Never touch the cylinder, muffler, or spark
plugs with your bare hands immediately after
stopping the engine. The engine can
become very hot when in operation, and
doing so could result in severe burns.
•When checking the machine to make sure
that it is okay before using it, check the area
around the muffler and remove any wood
chips or leaves which have attached
themselves to the stick edger. Failing to do
so could cause the muffler to become
overheated, and that this in turn could cause
the engine to catch on fire. Always make
sure that the muffler is clean and free of
wood chips, leaves, and other waste before
use.
• Check the intake air cooling vent and the area
around the cylinder cooling fins after every 25
hours of use for blockage, and remove any
waste which has attached itself to the stick
edger. Note that it is necessary to remove the
engine cover shown in (MA8) in order to be able
to view the upper part of the cylinder.
WARNING
IMPORTANT
(1)
(2)
MA8
(1)
(2)
(3)
(4)
(5)
MA7