Filter
Top Products
■ HE2200LDC
1.Install the blade guard to the gear case with
the provided 3 screws.
2.Place the blade between the cutter holders
(A) and (B) while locking the gear shaft by
putting the bar , one of the tools provided,
through the key holes on the holder(A) and
the gearcase. Use the socket and the bar
as shown in the picture below to tighten the
mounting nut.
3.Install the J-shaped handle to the shaft tube
and clamp at a position best for your job.
• ADJUSTING HANDLE POSITION
Loosen the handle bracket screws and
reposition the handle to your best operating
position. Re-tighten the screws.
1.Install the driveshaft assembly to the engine
unit. Clamp it securely with the attached
bolt and nut.
2.Connect the throttle cable to the engine.
3.Mount the handle to the driveshaft casing
and clamp it at a position suitable for
operation.
4.Install the debris guard to the bracket with
screws provided.
SETUP
BT2200LDC
Attach the guard above the clamp and slide
it down. Rotate it a half turn to set in place.
BC2200E
BC2200LDC
HE2200LDC
3