Filter
Top Products
GZ3500T
US-7
U
S
The port to refuel “MIX GASOLINE”
Position: Recoil case (in front of the fuel cap)
The port to fill chain oil
Position: Recoil case (under the oil cap)
Setting the switch to the “O” position, stops the engine immediately.
Position: Right side of the rear handle
Starting the engine. If you turn the choke knob to the point of the arrow,
you can set the starting mode as follows:
Position: Upper-right of the air cleaner cover
The screw under the “H” stamp is The High-speed fuel mixture adjust-
ment screw.
The screw under the “L” stamp is The Slow-speed fuel mixture adjust-
ment screw.
The screw at the left of the “T” stamp is the Idle speed adjustment screw.
Position: Left side of the rear handle
Shows the directions that the chain brake is released (white arrow) and
brake is activated (black arrow).
Position: Front of the chain cover
If you turn the rod with screwdriver follow the arrow to the "
" position,
the chain oil flows more, and if you turn to the " " position, oil flow is
less. (Standard width: 90°)
Position: Bottom of the power unit
For safe operation and maintenance, symbols are carved or placed on the ma-
chine.
According to these indications, please be careful not to make any mistake.
WARNING
■ EMISSION CONTROL
An emission control label is located on the engine.
*1: The year will be changed every year of manufacturing.
*2: The initial number will be changed every year of
manufacturing.
IMPORTANT EMISSIONS INFORMATION
USE JASO FD OR ISO L-EGD GRADE 50:1 OIL.
MANUFACTURED:
THIS ENGINE MEETS TO 2008*
1
U.S. EPA AND 2008*
1
CALIFORNIA EXH AND EVP EMISSION REGULATIONS
FOR SI SORE's. COMPLIANCE PERIOD : CATEGORY A
ENGINE FAMILY : 8HQZS.0354BT*
2
DISPL.: 35 cc
EMISSION CONTROL SYSTEM : EXH;EM
REFER TO OWNER'S MANUAL FOR MAINTE-
NANCE, SPECIFICATIONS AND ADJUSTMENTS.
4. Symbols on the Machine