Filter
Top Products
14
6. When engine has ignited, pull the throttle slightly
to return the choke knob to the original position.
If the engine stops, pull the starter again without
pulling out the choke knob.
7. Allow the engine to warm up with the throttle
lever pulled slightly.
Keep clear of the saw chain as it will start
rotatIng upon starting of engine.
■ CHECKING THE OIL SUPPLY
Make sure to set up the bar and the chain when
checking the oil supply.
If not, the rotating parts may be exposed. It is
very dangerous.
After starting the engine, run the chain at medium
speed and see if chain oil is scattered off as shown
in the figure.
(1) Chain oil
The chain oil flow can be changed by inserting a
screwdriver in the hole on bottom of the clutch
side.
Adjust according to your work conditions.
(1) Rich (2) Lean (3) Chain oil flow adjusting
■ ADJUSTING THE CARBURETOR
The carburetor on your unit has been factory
adjusted, but may require fine tuning due to a
change in operating conditions.
Before adjusting the carburetor, make sure that the
provided air/fuel filters are clean and fresh and the
fuel properly mixed.
When adjusting, take the following steps:
Be sure to adjust the carburetor with the bar chain
attached.
NOTE
WARNING
WARNING
7. Operation
F7-6
F7-7