Filter
Top Products
❲
12
❳
OP8
7. Operation
■ CHECKING OIL SUPPLY
After starting the engine, run the chain at medium
speed and see if chain oil is scattered off as shown
in the figure. (OP6)
The oil tank should become nearly empty by the
time fuel in the tank is used up. Be sure to refill the
oil tank every time when refueling the saw.
■ STOPPING ENGINE
1. Release the throttle lever and let the engine run
at low speed for a moment.
2. Put the ignition switch to the “O” position. (OP7)
In case of emergency, turn off the switch without
idling the engine.
■ ADJUSTING CARBURETOR
The carburetor has been adjusted at the factory.
Should your unit need readjustment due to the
changes in altitude or operating conditions, please
let your skillful dealer make the adjustment. A
wrong adjustment may cause damage to your unit.
If you have to make the adjustment yourself,
please carefully follow the procedure below.
Be sure to adjust the carburetor with the bar chain
attached.
1. H and L needles are restricted within the number
of turn as shown below, because this engine
conforms to 1995 California regulations for utility
and lawn and garden equipment engines as
applicable. (OP8)
H needle –1/2
L needle fixed
2. Start engine and allow it to warm up in low
speed for a few minutes. (OP8)
3. Turn idle adjusting screw (T) counter-clockwise
NOTE
NOTE
NOTE
OP6
OP7