Filter
Top Products
US-13
EBZ3050RH
U
S
■ MUFFLER
• Inspect periodically, the muffler for
loose fasteners, any damage or
corrosion. If any sign of exhaust
leakage is found, do not use the blower
and have it repaired immediately.
• Note that failing to do so may result
in the engine catching on fire.
• Before starting operation, always make
sure to check if the muffler is properly
held by two bolts (F17 (2)). (Fastening
Torque : 7 to 11 N·m)
• Also make sure that the spark arrester
and the diffuser are properly attached
with two bolts (F17 (1)). (Fastening
Torque : 2 to 3 N·m)
• Even if one of four bolts is loose, it may
result in engine catching on fire.
(1) Bolt
(2) Bolt
(3) Spark arrester
(4) Diffuser
■ SPARK ARRESTER
• The muffler is equipped with a spark
arrester to prevent red hot carbon from
flying out of the exhaust outlet.
Periodically inspect and clean as
necessary with a wire brush. In the
State of California it is required by law
(Section 4442 of the California Pulic
Resources Code) to equip a spark
arrester when a gas powered tool is
used in any forest covered, bush
covered, or grass covered unimproved
land.
■ PROCEDURES TO BE PERFORMED
AFTER EVERY 100 HOURS OF USE
1. Remove the muffler, insert a
screwdriver into the vent, and wipe
away any carbon buildup. Wipe away
any carbon buildup on the muffler
exhaust vent and cylinder exhaust port
at the same time.
2. Tighten all screws, bolts, and fittings.
■ AIR INLET NET
• Blowing air is taken in from the air inlet
IMPORTANT
IMPORTANT
WARNING
9. Maintenance
net. When air flow has dropped down
during operation, stop the engine and
inspect the air inlet net for blocking by
obstacles.
• Note that failure to remove any such
obstacles may result in the engine
becoming overheated and damaged.
(1) Net
Never use the blower without the net of
the blower. Before each use, check
that the net is attached in place and is
free from any damage.
■ IGNITION COIL AIR GAP
INSPECTION
• If the gap is out of standard or when
installing the coil or rotor, adjust the air
gap between the ignition coil and the
iron core of the rotor.
Air Gap:
0.3 ~ 0.4mm
0.012 ~ 0.016"
(1) Rotor
(2) Ignition coil
■ SHOLDER STRAP
• If the shoulder strap is damaged it may
break during use, thus causing the
product to fall and resulting in personal
injury. Follow the instructions below to
replace the shoulder strap with new
one.
1. Hook the upper part of the shoulder
strap at the notch on the top of the
frame and pass it through the buckle as
shown in the figure, then secure it
firmly.
2. Put the hook at the lower part of the
shoulder strap in the strap installing
location at the bottom of the frame.
(1) Buckle
(2) Frame
(3) Hook
(4) D-ring
WARNING
F19
F18
F17
F20
(1)
(2)
(3)
(4)
F21