Filter
Top Products
8
Qty Description *Key #
1 Upper Handle 4
1 Upper Handle Throttle Side 5
2 Lower Handles 6
1 Pair Cultivator Tines 39/40
1 Engine Assembly
(includes Fender Guard
& Worm-Gear Transmission) 21, 20, 50
1 Handle Brace 8
1 Plastic Carrying Handle 42
Qty Description *Key #
1 Bag of Hardware Containing:
4 Cap Screws 52
6 Lock Nuts 53
2 Bolts (3 1/4" long) 54
2 Tine Retaining Pins 41
2 Transmission Bracket 47
1 Throttle Clip 13
Your REDMAX Precision
Tiller/Cultivator comes partially
assembled. You must install only the
handlebars, the carrying handle, and
the tines. This will take just a few
minutes if you follow the directions.
First, take all items out of the
carton. But do not remove the
cardboard from around the
Tiller/Cultivator’s base.
The list below, shows the parts that
come with your Tiller/Cultivator.
Check to make sure you have them.
The bag of hardware is packed in the
plastic bag containing the owner’s
manual.
To assemble your REDMAX
Tiller/Cultivator, you’ll need two 7/16"
wrenches or two adjustable wrenches.
We suggest that you install all nuts and
bolts only “finger tight” — that is, one-
half to one full turn — until you’ve
completed assembly. The nuts are self
locking, but you must use a wrench
to tighten them completely.
Assembly Instructions
WARNING DANGER
IMPROPER ASSEMBLY OF THIS
TILLER/CULTIVATOR CAN RESULT IN
SERIOUS INJURY.
MAKE SURE TO FOLLOW ALL INSTRUCTIONS
CAREFULLY. IF YOU HAVE ANY QUESTIONS
CONTACT YOUR LOCAL REDMAX DEALER.
4
6
5
47
41
40
39
42
8
21
13
54
53
52
6