Filter
Top Products
❲
8
❳
■ CHT2300B/CHT2300L
1. Attach the engine to the clutch housing of
the cutter unit. Casually fix the front 2
points with the screws(.55" long)(15mm
long).
2. After connecting the ground wire, install
the rear handle to the clutch housing with
the screw(2" long)(50mm long) and the
nut.
3. Put the screw(1.6" long)(40mm long)
through the ground wire terminal and the
rear handle, and in to the engine mounting
base. Securely tighten all of the engine
mounting screws.
4. Attach the front handle onto the gear
housing and fasten with 2 screws(1.2"
long)(30mm long) and nuts.
5. Connect the throttle cable with the lever
on the rear handle, and secure the end
with the hardware attached to the handle.
6. Check the cable play and, if necessary,
adjust between .04" and .08" (1~2mm) by
bending throttle wire receiver of the
bracket with a nipper.
Set up