Filter
Top Products
15
6. Set up (BCZ3000S/BCZ3000SW)
SE10
SE11
■ INSTALLING DEBRIS GUARD
• Put the debris guard on the gear box, attach it
with the 2 screws. (SE9)
2 kinds of debris guard are packed in with
BC3000SW. Choose the guard suitable for a
cutting head. If the right guard is not used, it may
lead to a serious accident. (SE9)
(1) Guard for Line Head (Red)
(848-JC0-6610)
(2) Guard for Blade (Black)
(T3246-24110)
■ INSTALLING CUTTING HEAD (SE10)
1. While locking the gear shaft, by inserting the
supplied tool into the upper holder on the gear
box, loosen and remove the hexagon nut(left-
handed)
2. Fit the holder attached to the upper holder. Then
screw in the cutting head to the gear shaft over
the holders. Hand-tighten it securely.
You need not holder (B) and nut when installing the
cutting head.
■ BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Slide clamp up or down until unit balances with
head just touching on the ground. (SE11)
IMPORTANT
IMPORTANT
15
(1)
(2)
SE9