Filter
Top Products
•Avoid pulling the rope to its end or returning
it by releasing the knob. Such actions can
cause starter failures.
6.When the engine has started, move the
choke lever gradually downward to open
the choke.
7.Allow the engine to warm up for a half
minute before starting operation.
1.When restarting the engine immediately
after stopping it, leave the choke open.
2.Overchoking can make the engine hard to
start due to excess fuel. When the engine
failed to start after several attempts, open
the choke and repeat pulling the rope, or
remove the spark plug and dry it.
■ STOPPING ENGINE
1.Release the throttle lever and run the
engine for a half minute.
2.Shift the ignition switch to the STOP
position.
•Except for an emergency, avoid stopping
the engine while pulling the throttle lever.
NOTE
NOTE
NOTE
■ ADJUSTING IDLING SPEED
1.When the engine tends stop frequently at
idling mode, turn the adjusting screw
clockwise.
2.When the cutting head keeps rotating after
releasing the trigger, turn the adjusting
screw counter-clockwise.
•Warm up the engine before adjusting the
idling speed.
■ LINE HEAD USAGE
1.Always wear eye protection such as
safety goggles. Never lean over the
rotating cutting head. Rocks or other
debris could be thrown into eyes and
face and cause serious personal injury.
2.Keep the debris guard attached in
place at all times when the unit is
operated.
TRIMMING GRASS AND WEEDS
•Always remember that the TIP of the line
does cutting. You will achieve better results
by not crowding the line into the cutting
area. Allow the unit to trim at its own pace.
1.Hold the unit so the head is off the ground
and is tilted about 20 degrees toward the
sweep direction.
2.Use full throttle when cutting.
3.You can avoid thrown debris by sweeping
from your left to the right.
4.Use a slow, deliberate action to cut heavy
WARNING
NOTE
Operation
❲
13
❳