RedMax BC3400DL Brush Cutter User Manual


 
MOUNTING ENGINE
(BC2300DL & BC2600DL)
1. Remove the clamp temporarily attached to
the clutch housing.
2. Push the driveshaft toward the gearcase
and rotate it by hand to check that the
driveshaft is engaged with the gears.
3. Insert the shaft tube into the clutch
housing until it bottoms. When difficult to
engage, twist the engine slightly.
4. Align the positioning holes on the clutch
housing and the shaft tube and fit the boss
on the clamp into the holes. Fasten the
clamp securely.
(BC3400DL & BC4400DW)
• Put the engine onto the clutch side end of
the driveshaft assembly, making the fuel
tank and the cutter head come to the same
side. Attach the engine firmly with the 4
screw provided.
INSTALLING HANDLE
• Mount the handle to the shaft tube and
clamp it at your best operating position.
INSTALLING DEBRIS GUARD
• Put the debris guard on the shaft tube near
the gear box, attach it with the 2 screws
and hardware provided.
CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the
joint on the top of the carburetor.
(BC3400DL & BC4400DW)
• When installing the cleaner cover, make
sure to put the high-tension wire in it.
NOTE
Set up
9
BC4400DW