Filter
Top Products
4. Refit and tighten the oil filler plug.
Note: It is important to use the recommended oil to
avoid damage to your engine.
Petrol
Note: Petrol deteriorates over time. Engine starting
may be difficult if you use petrol kept for more than
30 days. Always run the fuel tank dry when storing
over 30 days
1. Remove the petrol filler cap Fig 5C and add
unleaded petrol to the tank, leaving approxi-
mately 6mm of tank space for fuel expansion.
2. Replace the petrol filler cap.
3. Wipe up any spilt petrol from the engine before
starting the mower.
Using your Mower
Grassbox Fitting
Grassbox
For non grass collection the mower can be used
without the grassbox in position, with the deflector
guard in the down position.
Fitting the grassbox
Lift the deflector guard and hold up Fig 6A
Fit the grassbox Fig 6B.
Removing/Emptying
Lift the deflector guard and hold up - remove
grassbox.
Height of Cut Adjustment
To adjust the front and rear wheels push the height-
of-cut lever Fig 7A away from the notch Fig 7B.
For front wheels
- Move lever to the rear to lower
wheels, as shown Fig 7.
For rear wheels
- Move lever forward to lower wheel
as shown Fig 7.
Always ensure that ALL FOUR WHEELS are at the
same height setting.
Before mowing
1. Check the engine oil level and fill the petrol
tank. (See Preparation).
Note: Towards the end of the season, it is
advisable to put only as much fuel in the tank
as you need for each cut, since it should be
completely used up before storing the mower.
(See After Mowing/Storage).
2. Ensure that the upper handle is in position and
secured by the wing nut Fig 2B.
3. Set the height of cut as required .(See Height of
Cut Adjustment).
Starting and Stopping
Starting the Engine
1. For mowers with throttle controls: Move the
throttle lever Fig 9A to
2. If the engine is cold, press the primer Fig 8A
three times (five times in cold weather). If the
engine is warm do not prime.
3. Hold the bale bar Fig 9B against the handle.
4. Pull the starter Fig 9C cord briskly one or more
times until the engine starts. Allow the cord to
return slowly after each pull.
Stopping the Engine
1. Release the bale bar Fig 9B. The engine will
stop within 3 seconds.
To drive the Rear Roller (Self-propelled
models only)
1. Start the mower (see above).
2. Squeeze the land drive bale bar Fig 9D towards
the top handle. For mowers with throttle
control, adjust the speed as required by moving
the throttle control Fig 9A between and
4. To stop the drive, release the land drive bale bar
Fig 9D.
After Mowing/Storage
Clean the exterior of the machine thoroughly using
a soft brush and cloth. Do not use water, solvents or
polishes. Remove all grass and debris, especially
from the ventilation slots.
Tip the machine backwards or on its side (see
Underdeck Access) Fig 10 and clean the blade
area. If grass cuttings are compacted in the blade
area, remove with a wooden or plastic implement.
For storage in excess of 30 days, run the engine until
all petrol is used and the engine stops.
Store the machine in a dry place. Do not place
other objects on top of the machine.
To aid storage loosen the handle wing nuts Fig 2B
and fold the handles.
Ensure cable is not trapped when folding/unfolding
top handles, DO NOT DROP THE HANDLES.
Maintenance
Stop the engine, and disconnect the spark plug wire.
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as loose,
dislodged or damaged blades, loose fixings, and
worn or damaged components. Check that covers
and guards are undamaged and correctly fitted.