Quadra-Fire 839-1440 Patio Heater User Manual


 
Page 34
January 28, 2008
Quadra-Fire · Sapphire · 250-7233F
H. Mineral Wool
Follow ember placement instructions in
manual.
Do NOT place embers directly over
burner ports.
Replace ember material annually.
Explosion Risk.
WARNING
Improperly placed embers interferes with proper burner
operation.
Figure 8.21 Place individual pieces of embers in front of and
around the gas log where they can be seen. Space them so
that gas can contact them on all sides. Avoid stacking the
embers on top of each other.
NOTE: Do not block gas ports.
J. Blower Installation
FROM THE KIT YOU WILL NEED: Blower motor; snap
disc bracket with wire harness; rheostat, rheostat nut; knob;
screws; 1 zip-tie.
TOOLS REQUIRED: #2 Phillips head bit; hand drill; 11/16
in. wrench.
Figure 8.22 Mount blower to rear of the appliance using two
screws.
Blower
mounting
bracket
beneath
appliance
as seen
from front.
Ensure
these
wires are
BEHIND
the
mounting
bracket.
Wire Harness
Connector
Blower from front
view beneath
appliance.
Figure 8.23 Beneath the appliance from its front side, ensure
that all wiring is moved behind the blower mounting bracket
which already comes installed on the bottom of the appli-
ance. Complete blower mounting by inserting two screws
through the blower into the mounting bracket. Make the wire
harness connection.
I. Glass Door Assembly Installation
Remove the glass door assembly by opening latches at the
bottom front of the appliance, on both the left and right sides.
Lift out and away from the appliance.
Replace with a new glass door assembly.
Handle glass assembly with care.
CAUTION
Inspect the gasket to ensure it is undamaged.
Inspect the glass for cracks, chips or
scratches.
Do NOT strike, slam or scratch glass.
Do NOT operate appliance with glass door
removed, cracked, broken or scratched.
Replace glass assembly as a complete
assembly.