Filter
Top Products
Page 24
January 28, 2008
Quadra-Fire · Sapphire · 250-7233F
A
B
C
Figure 6.6 Turn control knob to the OFF position, ensure that
gas supply to the valve has been turned off. Using a Torx
TH20, or slotted screwdriver, remove the three pressure reg-
ulator mounting screws (A), pressure regulator tower (B),
and diaphragm (C).
2. Valve Regulator Replacement
Remove upper and lower back shield. Loosen the set col-
lars on the extension rods with the 3/32 in. Allen wrench.
Remove the rods and adapter cap.
Fire Risk.
Explosion Risk.
• Disconnect any electrical cords and
turn off gas supply to unit before
proceeding if converting fuel on an
appliance already fully installed.
WARNING
IMPORTANT NOTE! The orifi ce supplied with the con-
version kit is for installations with vertical rise. If your
appliance was fi tted with the rear vent kit, the correct
conversion orifi ce was supplied WITH THE REAR VENT
KIT.
PROPANE NATURAL GAS
Top Vent .063 (52 DMS) .106 (36 DMS)
Rear Vent
(no vertical) .059 (53 DMS) .096 (41 DMS)
Figure 6.5 Replace orifi ce with the proper size as indicated
below for your gas type and venting. Re-install burner. Slide
burner neck into shutter and over orifi ce. Re-install burner
pan locators on left and right side of the burner. Secure with
one screw to each side.
Replace logs, glass door and front.
Replace pilot injector with the one supplied in the conversion
kit (#35 for Propane, #62 for Natural Gas).
NOTE: The injector is ONLY replaced if you are convert-
ing to another gas. It is not replaced for a change
from top to rear vent.
Replace pilot hood, snapping into position.
Remove main burner orifi ce using a 5/8" wrench.