Filter
Top Products
16
LUBRICATION:
A properly maintained lubrication schedule will provide a smooth running machine for
many years. The following information shows and describes where all lubrication points
are located.
DECK P.T.O. SHAFTS
Spindles* (See Manual)
*As Required
Main Input*(See
Below)
Pull Apart Sliding
Tubes once per week and
lubricate
*As Required
CHECK FOR PROPER OIL LEVEL IN GEARBOXES DAILY
GREASING SCHEDULE & LOCATION
BLADE SPINDLE GREASING:
The top bearing on all spindle assemblies has a shield only. This allows grease to exit
and relieves any pressure build up inside spindle housing, when greasing. Greasing of
blade spindles should continue until grease can be seen exiting between the top bearing
and the bottom of hub on pulley. Some working conditions will require this operation
to take place every 4 to 5 running hours because of hot working areas. Cooler working
areas will only require greasing every 8 to 10 hours. A proper greasing schedule can
only be determined by operator, depending on working conditions in your particular
area.