Filter
Top Products
4. Insert a Support Ball (8) into each mesh pocket on
the underside of the Spa Cover (12).
See inset drawing A. Insert the inflation tube into the
hole in one of the Support Balls (8). Inflate the
Support Ball.
See inset drawing B. When the Support Ball (8) is
inflated, remove the inflation tube and insert the ball
plug through the mesh into the Support Ball. The
head of the ball plug will hold the Support Ball in
place.
Inflate the other Support Ball (8) in the same
manner.
Note: The Support Balls (8) are not toys.
5. Place the Spa Cover (13) over the RESTORATION
2.0. Be sure that the Spa Cover is properly cen-
tered.
Snap a Buckle (2) onto each of the eight latches on
the Spa Cover (13).
See the inset drawing. Position one of the Buckles
(2) on the wood panels on the Spa Unit (15) and
hold the Buckle in place, so the strap on the Spa
Cover (13) is tight. (Note: It may be easier to posi-
tion the Buckles if a second person holds the strap
on the opposite side of the Spa Cover tight.) The
Spa Cover must be tight. Do not place the
Buckle over one of the grooves in the wood
panels. Remove the latch. Attach the Buckle to the
side of the spa with two Buckle Screws (1). Note: It
may be helpful to use a hammer and a nail to
tap starter holes in the wood panels. You may
also want to apply a little soap or wax to the
screw threads.
Attach the other seven Buckles (2) to the Spa Unit
(15) in the same manner.
Remove the Spa Cover (13) after you have
attached the Buckles (2).
Fully read the section USING THE RESTORA-
TION 2.0 before using the spa.
9
1
Latch
Strap
2
2
15
13
5
B
8
Mesh Pocket
12
8
Ball
Plug
8
A
Inflation
Tube
4