Powermate P-WLE-0799-F2N Edger User Manual


  Open as PDF
of 43
 
Questions? Call Toll Free at 1-800-737-2112 Copyright © 2009 MAT Engine Technologies, LLC
How to Prepare for Storage
H
Never store the edger indoors with fuel in the fuel tank. Never store in an enclosed, poorly ventilated area where fumes
couldreachanopename,asparkorapilotlightasonafurnace,waterheaterorclothesdryer.Allowenginetocool
before storing unit.
Donotremovegasolinewhileinsideabuilding,nearare,orwhileyousmoke.Gasolinefumescancauseanexplosion
orare.
NOTE: A yearly checkup or tune-up at an authorized service center will make sure that the edger will provide maximum
performance for the next season.
When the edger is put in storage for thirty days or more, the following steps should be followed to make sure the edger is in good
condition the next season.
1. Let the engine run until it is out of gasoline.
2. Change the oil by following
instructionsunder“HowtoChangetheOil.”
3. Remove the spark plug from the cylinder. Pour one ounce of oil into the cylinder. Slowly pull the recoil-start grip so
that the oil will protect the cylinder. Install a new spark plug in the cylinder. Pull starter handle slowly a few times to
distribute oil. Pull recoil slowly until resistance is felt. This will close the cylinder valves.
DO NOT attach spark plug wire to spark plug when storing unit.
4. Clean edger. Remove all dirt, leaves, debris, grease, etc. from the edger - including cylinder cooling fans, recoil starter
coverholes,underfueltank,andundermufer.
5.Checktheedgerforwornordamagedparts.Havedamagedpartsreplacedifnecessary.
6. Tighten any loose hardware.
7. Apply lubrication as directed in Maintenance section.
8. Put the unit in a building that has good ventilation.
9. Cover the edger with a breathing material.
Maintenance (Continued)
• Save all instructions
15
WARNING
WARNING
WARNING
 previous next