Filter
Top Products
Ch6ck Brake Operation _V r
Check Tire Pressure
Check Operator Presence and
T Int_dock Systems If
R CheckforLooseFasteners V# _7 If /
Sharpen/Replace Mower Blades I_4
T Lubrication Chad _ If
0 Check BaRe,"/Level
R Clean Battery and Terminals
Check Transaxle Cooling !_
Adjust Blade Belt(s) Tension II_s
Adjust Motion Drive Belt(s) Tens_n !,_s
Check Engine Oil Level V w
Change Engine Oil _t2,= V'
E Clean Air Filter Vw2
N CleanAirScreen _z
G Inspect Muffier/Spark Arrester if
NI (if equipped) _.z
Replace
Oil Filler
E Clean Engine Cooling Fins 1_2
Replace Spark Plug _#z if
Replace Air Filter Paper Cartridge
Replace Fuel Filter I_
1 "Ch_r'cJe more oldenwhen opemling Lmdera heaw load or i_h_ amblenl tempemtum¢_ 5 - If equipped withadjuslBble system.
2 - Se_ice morn of_n whenoperating kl dirty ordusty coP_16ons. 6 -Not requiredifequipped with_n_u_e-_ee batte_y.
3 - Ifequipped withoilfiler, changoOllever/50 hours, 7 - 3_htan ftor,t axle pivot bo_l_ 35 It_1_1.mm_mum.
4 - Replace 1:4ad_ moseo_en when mow_g insan_ scd+ DO no_o_dighi_.
GENERAL RECOMMENDATIONS
The warranty on this tractor does not
cover items that have been subjected to
operator abuse or negligence. To
receive full value from the warranty,
operator must maintain tractor as
instructed in this manual.
Some adjustments will need to be made
periodically to properly maintain your
tractor.
All adjustments in the Service and
Adjustments section of this manual
should be checked at least once each
season.
• Once a year you should replace the
spark plug, clean or replace air filter,
and check blades and belts for wear.
A new spark plug and clean air filter
assure proper air-fuel mixture and
help your engine run better and last
longer.
BEFORE EACH USE
• Check engine oil level.
• Check brake operation.
• Check tire pressure.
• Check operator presence and
interlock systems for proper operation.
• Check for loose fasteners.
LUBRICATION CHART
Zerk Zerk
Bearing
Zerk
Bearing Zerk
( i
I :
I I
i :
I I :
(_SAE OR 10W30 MOTOR OIL
_)REFER TO MAINTENANCE "ENGINE"
SECTION
IMPORTANT" DO not oil or grease the
pivot points which have special nylon
bearings. Viscous lubricants will attract
dust and dirt that will shorten the life of
the self-lubricating bearings. If you feel
they must be lubricated, use only a dry,
powdered graphite type lubricant
16 sparingly.