Filter
Top Products
7
SCALPING -- The scalping technique re-
moves unwanted vegetation down to the
ground. Hold the bottom o f the trimmer head
about 3 inches (8 cm) abo ve the ground a nd
atanangle.Allowthetipofthelinetostrikethe
ground aroundtrees, posts, monuments,etc.
This technique increases line wear.
Scalping
3 inches (8 cm)
above g round
MOWING -- Your trimmer is ideal for mowing
in places conventional lawn mowers cannot
reach. In the mowing position, keep the line
parallel to the g round. Avoid pressing the
head into the ground as this can scalp the
ground and damage the tool.
Mowing
SWEEPING-- Thefanning actionof therotat-
ing line can be used for a quick and easy
clean up. Keep the line parallel to and above
the surfaces being swept and move the tool
from side to side.
Sweeping
EDGING -- Adjust trimmer tothe edgingposi-
tion (see TWIST AND EDGE section). Allow
onlythe tipofthelinetomake contact. Donot
force trimmer line into work area.
Edging
MAINTENANCE
WARNING: Disconnect the spark
plug before performing maintenance except
for carburetor adjustments.
HELPFUL TIP
IMPORTANT: Have all
repairs other than the rec-
ommended maintenance
described in theinstruction
manual performed by an
authorized service dealer.
If any dealer other than an authorized
service dealer performs work o n the
product,WEED EATER m aynot pa yfor
repairs under warranty. I t is your re-
sponsibility to maintain and perform
general maintenance.
CHECK FOR LOOSE
FASTENERS AND PARTS
S Spark Plug Boot
S Air Filter
S Housing Screws
S Assist Handle Screws
S Debris Shield
CHECK FOR DAMAGED OR
WORN PART S
Contact an authorized service dealer for re-
placement of damaged or worn parts.
S STOP Switch -- EnsureSTOP switchfunc-
tions properly by pushing and holding the
switchin theSTOP position.Make sureen-
gine stops. Restart engine and continue.
S Fuel Tank -- Discontinue use of unit if fuel
tank shows signs of damage or leaks.
S Debris Shield -- Discontinue use of unit if
debris shield is damaged.
INSPECT AND CLEAN UNIT AND
LABELS
S After each u se, inspect complete unit for
looseor dam agedparts. Cleantheunitand
labels using adampcloth witha mild deter-
gent.
S Wipe of f unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine perform-
ance and increases fuel consumption and
harmful emissions. Always clean after every
5 hours of operation.