Filter
Top Products
8
SERVICE AND ADJUSTMENTS
LINE REPLACEMENT
Pre--wound spools offer the most convenient
method for replacing line and ensuring opti-
mum performance.
S
Replacement spools are color--coded to en-
sure use of the correct spool with your unit.
Be sure to use the same color spool as the
existing spool.
NOTE
: Always clear dirt and debris from
cutting head components when performing
any type of maintenance.
S
Hold spool and unscrew cap by turning in the
direction show n on top of the cap.
S
Remove line guide r ing and spool.
NOTE:
Whenremovingand/or installingspool,
ensure dust cup remains installed over shaft.
Use a pre--wound spool or refill spool with
line. If using a pre--wound spool, remove tape
strip from line and spool.
REFILLING THE SPOOL WITH LINE
WARNING:
Use only 0.080” (2 mm)
diameter round line. Other sizes and shapes
of line w ill not advance properly and will result in
impropercutting head function or can cause se-
rious injury. D o not use other materials such as
wire, string, r ope, etc. Wire can br eak of f during
cutting and become a dangerous m issile that
can c ause serious injury.
1. Cut a length of 30 feet of 0.080” (2 mm) di-
ameter round Weed Eater
"
brand line.
Feed line in
direction
shown on
spool.
Spool
2. Insert one end of line into center cavity of
empty spool. Ensure line will feed into
spool in the direction shown on the spool
(counterclockwise) .
3. Continue feeding line into spool, leaving 4 --
6 inches (10 -- 15 cm)unwoundfromcenter
of spool.
INSTALLING SPOOL WITH LINE
1. Install replacement spool.
2. Thread line through line guide ring.
Line through guide ring
Replacement Spool
Slot
3. Rest guide ring on spool and place line
through slot. Allowline to extend 4 -- 6 inch-
es (10 -- 15 c m) from center of spool.
4. Ensure line r em ains in sl ot while screwing
capontotheshaft. Only t ight en cap
hand tight !
CARBURETOR ADJUSTMENT
Your carburetor is equipped with limiter caps.
Carburetor adjustment is a complicated task.
We recommend that you take your unit to an
authorized service dealer. Damage willoccur
if you turn the needles beyond the limiter
stops.
STORAGE
WARNING:
Perform the following
steps after each use:
S
Allow engine to cool, and secure the unit
before storing or transporting.
S
Store unit and fuel in a well ventilated area
where fuel vapors cannot reach sparks or
open flames from water heaters, electric
motors or switches, furnaces, etc.