Poulan SB180 Trimmer User Manual


 
-- 3 --
MAINTAIN YOUR UNIT PROPERLY
D
Have all maintenance other than the rec-
ommended procedures described in the
Operator’s Manual performed by your
Service Dealer.
D
Disconnect spark plug before performing
maintenance except for carburetor adjust-
ments.
D
Use only recommended WEED EATER
replacement parts; use of any other parts
may void your warranty and cause dam-
age to your unit.
D
Empty the fuel tank before storing the unit.
Use upfuel left in carburetor by starting the
engine and letting it run until it stops.
D
Do not use any accessory or attachment
other than those recommended by t he
manufacturer for use with your unit.
D
Donot store the uni t orfuel in aclosed area
where fuel vapors can reach sparks or an
open flame from water heaters, electric
motors or switches, furnaces, etc.
D
Store in a dry area out of reach of children.
SPECIAL NOTICE:
For users on U.S.
Forest Land and in some states, including
California(Public Resources Codes 4442
and 4443), Idaho, Maine, Minnesota, New
Jersey,Oregon, andWashington: Certain in-
ternal combustion engines operated on for-
est, brush, and/or grass covered land in the
above areas are required to be equi pped
with a spark arrestor, maintained in effective
working order, or the engine must be con-
structed, equipped, and maintained for the
prevention of fire. Check with your state or
local authorities for regulations pertaining to
these requirements. Failure to follow these
requirements is a violation of the law. This
unit is not factory equipped with a spark a r-
restor; however,a spark arrestor isavailable
as an optional part. If a spark arrestor is re-
quired in your area, contact your Authorized
Service Dealer for the correct kit. The spark
arrestor, blower tubes, and nozzles must be
assembled tothe unit to be in full compliance
with the regulations.
SPECIAL NOTICE:
Exposure to vibra-
tions through prolonged use of gasoline
powered hand tools could cause blood ves-
sel or nerve damage in the fingers, hands,
and joints of people prone to circulation dis-
orders or abnormal swelling. Prolonged use
in cold weather has been linked to blood ves-
sel damage in otherwise healthy people. If
symptoms occur such as numbness, pain,
loss of strength, change in skin color or tex-
ture, orloss offeeling inthe fingers, hands, or
joints, discontinue the use of this tool and
seek medical attention. An antivibration sys-
tem does not guarantee the avoidance of
these problems. Users who operate power
tools on a continual and regular basis must
monitor closely their physical condition and
the condition of this tool.
SAFETY RULES
ASSEMBLY
PREPARATION
WARNING:
If you receive your unit
assembled, check each step to insure your
unit is properly assembled. Follow all safety
information in the manual and on the unit.
D
No tools a re required for assembly.
BLOWER TUBE ASSEMBLY
D
Assemble the blower tube and nozzle to
the unit (turn clockwise to tighten).
Blower
Tube
Nozzle
Blower
Outlet
NOTE:
An optional vacuum kit is available
for your unit. See your local retailer or call
1--800--554--6723 for details.
SAFETY RULES
USING YOUR UNIT
YOU MUST make sure the tubes are secure
before using the unit.
BLOWER
Eye
Protection
SAFETY RULES
FUELING
This engine is certified to operate on un-
leaded gasoline. Gasoline must be mixed
with a good quality 2-cycle air-cooled engine
oil designed to be mixed at a ratio of 40:1.
Poulan/Weed Eater brand oil is r ecom-
mended. (A 40:1 ratio is obtained by mixing
3.2 ounces of oil with 1 gallon of unleaded
gasoline). When mixing fuel follow the
instructions printed on the container. Always
read and follow safety r ules under HANDLE
FUEL WITH CAUTION in the SAFETY
RULES section.