Poulan PPB430VS Blower User Manual


 
-- 6 --
blower tubes. The rotating blades can cause
serious injury.
1. Insert the tip ofa screwdriver intothe latch
area of the vacuum inlet.
Latch
Area
Blower
Outlet
Vacuum Inlet Cover
Latch
A
rea
2. Gently tilt t hehandle ofthe screwdriver t o -
ward the front of the unit to release the
latch while pulling up on the vacuum inlet
cover with your other hand.
3. Hold the v acuum inletcover open untilup-
per vacuum tube is installed.
Vacuum
Inlet
Cover
Vacuum Inlet
c
4. Align the tabs onthe i nside ofthe vacuum in-
let with the slots on the upper vacuum tube.
Tab
Slot
5. Push the upper vacuum tube into the v ac-
uum inlet. Turn t he t ube c ounterclockwise
until a click is felt to secure the tube to the
blower unit.
6. Align s lantedend oflower vacuum tubeas
shown. Firmly push lower vacuum tube
into upper vacuum tube.
Slanted end of
lower vacuum tube
HOW TO CONVERT UNIT FROM
VACU UM USE TO BLOWER USE
1. Remove the elbow tube a nd vacuum bag
by turning the knob counterclockwise to
loosen the elbow tube.
2. Remove the vacuum tubes by turning the
tubes clockwise.
3. Close the vacuum inlet cover and make
sure it is latched closed.
4. Reinstall the blower tubes (see BLOWER
TUBE ASSEMBLY).
SHOULDER STRAP ADJUSTMENT
1. Hold the unit as shown with the m uffler side
facing away from your body and clothes.
2. Pass the shoulder strap over your head
and onto your rig ht shoulder.
3. Extend your left arm toward the rear ofthe
vacuum bag.
4. Adjust shoulder strap until the vacuum
bag/shoulder strap seam lies between
your thumb and index finger .
5. Make sure air flows freely from the elbow
tube into bag. If bag is kinked, the unit will
not operate properly.