Filter
Top Products
5
spool. Leave 4--6 inches (10--15 cm) of line
unwound.
S
Insert line into the line exit hole in the hub.
S
Push spool into hub. Press spool down,
then turn i t to catch spool tabs under gear
tabs.
S
Re-install t he tap button, lock ring, and cover.
S
Pull the end of the line to set spool in the op-
erating position.
SERVICE
We recommend all service and adjustments
not listed in this manual be performed by an
Authorized Service Dealer.
CARBURETOR ADJUSTMENTS
Your carburetor is equipped with limiter caps.
Carburetor adjustments is a complicated
task. We recommend that you take your unit
to an Authorized Service Dealer. Damage will
occur if you turn the needles beyond the limit-
er stops.
IGNITION TIMING
The ignition timing is fixed, non--adjustable.
SPARK PLUG
Replace the spark plug yearly using a Cham-
pion RCJ--8Y plug. Spark plug gap is 0.025”.
NEED ASSISTANCE?
Need Assistance?
Call 1-800-554-6723.
Need Service Part?
Contact your dealer.
TROUBLE CAUSE REMEDY
Engine will not
start.
S
Engine flooded.
S
Fuel tank empty.
S
Spark plug not firing.
S
Fuel not reaching carburetor.
S
Carburetor requires adjustment.
S
See “Starting.”
S
Fill tank with correct fuel mixture.
S
Install new spark plug.
S
Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
S
See “Carburetor Adjustments.”
Engine will not
idle properl y.
S
Carburetor requires adjustment.
S
Throttle trigger screw too
tight.
S
See “Carburetor Adjustments.”
S
Loosen screw.
S
Air filter dirty.
S
Spark plug fouled.
S
Carburetor requires adjustment.
Engine will not
accelerate,
lacks power,
or dies under
a load.
S
Clean or replace air filter.
S
Clean or replace spark plug; re-gap.
S
See “Carburetor Adjustments.”
Engine
smokes
excessively .
S
Fuel mixture incorrect.
S
Air filter dirty.
S
Carburetor requires adjustment.
S
Empty fuel tank and refill with
correct fuel mixture.
S
Clean or replace air filter.
S
See “Carburetor Adjustments.”
Line does not
advance or
breaks while
cutting.
S
Line improperly routed in head.
S
Line improperly wound in
spool.
S
Line size incorrect.
S
Check line r outing.
S
Rewind line tightly and evenly.
S
Use only 0.080” (2 m m) dia. line.
TROUBLESHOOTING TABLE
WARNING:
Always stop unit anddisconnect spark plug before performing any ofth
e
recommended remedies below ot her than remedies t hat require operation of the unit.
Line welds
onto spool.
Line pulls
back into
head.
S
Line size incorrect.
S
Incorrect spool.
S
Line is being crowded against
material being cut.
S
Use only 0.080” (2 m m) dia. line.
S
Replace with correct s pool.
S
Cut with tip of l ine fully extended.
S
To o little line outside of head.
S
Line size incorrect.
S
Remove spool and pull 4 -- 6 inches
(10 -- 15 cm) of line out side of head.
S
Use only 0.080” (2 m m) dia. line.