Filter
Top Products
7
Coupler Primary Hole
Upper
Shaft
Locking/
Release
Button
Lower
Attachment
Guide Recess
WARNING: Make sure the locking/
release button is locked in the primary hole
and the knob is s ecurely tightened before op-
erating the unit. Al l atta c hment s ar e designed
to be used in the primary hole unless otherwise
stated in the applicable attachment instruction
manual. Using the wrong h ole could l ead toseri-
ous injury or damage to the unit.
Locking/Release
Button in Primary Hole
Secondary Hole
For optional attachments, see the AS-
SEMBLY section of the applicable attach-
ment instruction manual.
ATTACHING SHIELD
WARNING: The shield must be prop-
erly installed. Th e shieldprovides partial protec-
tion from the risk of thrown objects to the opera-
tor and others and is equipped with a line limiter
blade which cuts excess l ine to t he proper
length. The line limiter blade (on underside of
shield) is sharp and can cut you. For proper
orientatio n of shield, see KNOW YOUR TRIM-
MER illustration in OPERATION section.
1. Remo ve wing nut from shield.
2. Insert bracket into slot as shown.
3. Pivotshielduntilbolt passes th roughhole
in bracket.
4. Securely tighten wing nut onto bolt.
Slot
Shield
Wing
Nut
Bracket
Line Limiter Blade
ADJUSTING THE ASSIST HANDLE
WARNING: When adjusting the assist
handle, besure i t r emains above t he safety label
and below the mark or arrow on the shaft.
1. Loosen wing nut on handle.
2. Rotate the h andle on the shaft to an up-
right position; retighten wing nut.