Poulan PO17542LTX Lawn Mower User Manual


 
21
SERVICE AND ADJUSTMENTS
FIG. 18
FIG. 20
TO REPLACE MOTION DRIVE BELT
(See Fig. 20)
Park the tractor on level surface. En gage parking brake.
For as sis tance, there is a belt installation guide decal on
bottom side of left footrest.
BELT REMOVAL -
Remove mower (See “TO RE MOVE MOWER” in this
section of manual).
NOTE: Observe entire motion drive belt and position of all
belt guides and keepers.
Remove belt from stationary idler and clutching idler.
Remove belt downward from around en gine pulley.
Pull belt slack toward rear of trac tor. Remove belt
upwards from transaxle pulley by de flect ing belt keep-
ers.
Remove belt from center span keeper and pull belt
away from tractor.
BELT INSTALLATION -
Carefully work new belt down be tween transaxle belt
keepers and onto the input pulley.
Slide belt into the center span keeper.
Pull belt toward front of tractor and roll around the top
groove of engine pulley.
Install belt through stationary idler and clutch ing
idler.
Make sure belt is in all pulley grooves and in side all
belt guides and keep ers.
Install mower (See “TO IN STALL MOWER” in this sec-
tion of manual).
IDLER PULLEYS
MANDREL PULLEYS
TRANSAXLE
PULLEY
STA TION ARY
IDLER
CLUTCHING
IDLER
ENGINE
PULLEY
CENTER SPAN
KEEPER
TO CHECK BRAKE
If tractor requires more than five (5) feet to stop at highest
speed in high est gear on a level, dry concrete or paved
surface, then brake must be serviced.
You may also check brake by:
1. Park tractor on a level, dry concrete or paved surface,
depress clutch/brake pedal all the way down and en-
gage parking brake.
2. Place gear shift lever in neutral (N) position.
The rear wheels must lock and skid when you try to manu-
ally push the tractor forward. If the rear wheels rotate, then
the brake needs to be serviced. Contact a qualified service
center.