Filter
Top Products
19
MAINTENANCE
MUFFLER
Inspect and replace corroded muffl er and spark arrester
(if equipped) as it could create a fi re hazard and/or dam-
age.
SPARK PLUGS
Replace spark plugs at the beginning of each mowing
season or after every 100 hours of operation, whichever
occurs fi rst. Spark plug type and gap setting are shown in
“PROD UCT SPECIFICATIONS” section of this manual.
IN-LINE FUEL FILTER (See Fig. 17)
The fuel fi lter should be replaced once each season. If fuel
fi lter becomes clogged, ob struct ing fuel fl ow to car bu re tor,
re place ment is re quired.
• With engine cool, remove fi lter and plug fuel line sec-
tions.
• Place new fuel fi lter in position in fuel line with arrow
pointing towards carburetor.
• Be sure there are no fuel line leaks and clamps are
properly positioned.
• Immediately wipe up any spilled gasoline.
CLAMP
FUEL
FILTER
CLAMP
FIG. 17
CLEANING
• Clean engine, battery, seat, fi nish, etc. of all foreign
matter.
• Keep fi nished surfaces and wheels free of all gasoline,
oil, etc.
• Protect painted surfaces with automotive type wax.
We do not recommend using a garden hose or pressure
washer to clean your tractor unless the engine and trans-
mission are covered to keep water out. Water in engine or
transmission will shorten the useful life of your tractor. Use
compressed air or a leaf blower to remove grass, leaves
and trash from tractor and mower.
ENGINE OIL FILTER
Replace the engine oil fi lter every season or every other
oil change if the tractor is used more than 100 hours in
one year.
AIR FILTER (See Fig. 16)
Your engine will not run properly using a dirty air fi lter.
Replace pre-cleaner after every 25 hours of operation or
every season. Service paper cartridge every 100 hours of
operation or every season, whichever occurs fi rst.
Service air cleaner more often under dusty conditions.
• Pull up on air fi lter cover handle and rotate towards
engine.
• Remove cover.
• Carefully remove air fi lter cartridge and pre-cleaner
from base.
• Clean base carefully to prevent debris from falling into
carburetor.
NOTE: If very dirty or damaged, replace cartridge.
• Place new pre-cleaner and cartridge fi rmly in base.
• Align tabs on cover with slots in blower housing and
replace cover.
• Hook handle on cover and push down on handle to
close.
IMPORTANT: Petroleum solvents, such as kerosene, are
not to be used to clean the cartridge. They may cause
de te ri o ra tion of the cartridge. Do not oil cartridge. Do not
use pres sur ized air to clean cartridge.
BASE
CARTRIDGE
PRE-CLEANER
COVER
FIG. 16)
HAN DLE
NOTE: Operating the engine with a blocked grass screen,
dirty or plugged cooling fi ns, and/or cooling shrouds re moved
will cause engine damage due to overheating.
SLOTS
TABS