Poulan P3314WS Chainsaw User Manual


 
8
3. Using bar tool, roll chain around guide bar
to ensure al l links a re in b ar groove.
4. Lift up tip of guide bar to check for sag.
Release tip of guide bar, then turn ad-
justingscrew
1
/
4
turnclockwise. Repeat
until sag does not exist.
Adjusting Screw --
1
/
4
Turn
5. While lifting tip of guide bar, t ighten bar
nuts securely with the bar tool.
Bar Nuts
6. Use the screwdriver end of the bar tool
to move chain around guide bar.
7. If chain does not rotate, it is too tight.
Slightly loosen bar nuts and loosen
chain by turning the adjusting screw
1
/
4
turn counterclockwise. Retighten bar
nuts.
8. If chain is tooloose,it will sag belowthe
guide bar. DO NOT operate t he s aw if
the chain is loose.
WARNING: If the saw is operated
with a loose chain, the chain could jum p off
the guide bar andresult in serious injury.
OPERATION
KNOW YOUR C HAIN SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SA W. Compare t heillustrations with your unitto familiarize yourself with the locationof
the various controls and adjustments. Save this manual for future reference.
Chain
Adjustment Tool
(Bar Tool)
Primer Bulb
Starter H ousing
Bar Oil Fill Cap
Chain
Front Hand Guard
Front Handle
Starter Rope
ON/STOP
Switch
Muffler
Choke/
Fast Idle
Lever
Fuel Mix Fill Cap
Bar
Sprocket
Hole
Guide Bar
Bar Nuts
Cylinder Cover
Throttle
Lockout
Rear
Handle
Throttle
Trigger
Chain
Brake
Chain
Direction
of Travel
Adjusting Screw
Chain
Catcher
Clutch Cover
ON/ST OP S WI TCH
The ON/STOP SWITCH is used to stop the
engine.
THROTTLE TRIGGE R
The THROTTLE TRIGGER controls engine
speed.