Filter
Top Products
7
NOTE: If you are unable to locate the
inlet restrictor, the unit will still operate.
This restrictor improves the blower
function.
S
Close the inlet cover and make sure it
is latched closed.
S
Re-install the blower tube. Refer to
ATTACHING THE BLOWER TUBE
for
instructions on how to attach this item.
SELECT AN EXTENSION CORD
Use only a 120 A.C. voltage supply as
shown on nameplate of the unit to
power your blower.
D
To reduce the risk of electrical shock,
this equipment has a polarized plug
(one blade is wider than the other) and
will require the use of a polarized
extension cord. The appliance plug
will fit into a polarized extension cord
only one way. If the plug does not fit
fully into th e exten s io n cord, reve rs e
the plug. If the plug still does not fit,
obtain a correct polarized extension
cord. A polarized extension cord will
require the use of a polarized wall
outlet. This plug will fit into the
polarized wall outlet only one way. If
plug does not fit fully into the wall
outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to
install the proper wall outlet. D o not
change the equipment plug, extension
cord receptacle, or extension cord
plug in any way.
The extension cord used to reach the
power source must be:
D
Specifically m arked as suitable for out-
door use. Thecord m ustbe markedwith
the suffix “W-A” (in Canada “W”).
D
Heavy enough to carry full current from
the power source to the unit. Otherwise,
loss of power and overheating can oc-
cur causing damage to unit. Refer to
table for minimum wire gauge recom-
mendations. The cord must be ma rked
with the proper w ire gauge. (Appropriate
extension cords are available.) Do not
use multiple cords.
D
In good condition. Cord insulation m ust
be intact with no cracks or deterioration.
Plug connectors must be undamaged.
DO NOT
use multiple cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOLTS
25 FT. 50 FT. 100 FT.
120 16
A.W.G.*
16
A.W.G.*
*American Wire Gauge
14
A.W.G.*
Secure the extension cord to the unit by
threading the cord through the cord re-
taine r (see illus tra tio n). Ins e r t th e cord
receptacle into the recessed plug.
Cord
Retainer
Cord
Receptacle
Recessed
Plug
on Unit
USING YOUR UNIT
WARNING:
You
MUST
make
sure the tubes are secure before using
the unit.
WARNING:
Do not use the unit
without the tubes or collection bag
properly attached to avoid flying debris
and/or impeller contact which can
cause s erious injury. Always wear eye
protection to prevent rocks or debris
from being blown or ricocheting into
the eyes and face which can result in
blindness or serious injury.
STOPPING YOUR UNIT
Slide the
ON/OFF
switch to the
OFF
position.
STARTING YOUR UNIT
Your unit has two run positions,
LOW
and
HIGH
. Slide the switch to one of
these positions to turn on the unit.
OPERATING POSITION
Eye Protection
Blower
Eye Protection
Vacuum