Filter
Top Products
8
OPERATION
ON / OFF switch - used to STOP the engine.
Traction drive control lever - used to engage power-
pro pelled for ward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control knob - used to change the
di rec tion the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
Toolbox - used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for start ing en gine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Choke control - used for starting a cold engine.
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
MUF FLER
TOOLBOX
HANDLE
KNOB
CHUTE
DE FLEC TOR
DISCHARGE
CHUTE
AU GERS
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
FIG. 8
CLEAN-OUT
TOOL
SKID PLATE
DEFLECTOR REMOTE
CONTROL LEVER
TRACTION DRIVE
CONTROL LEVER
DISCHARGE
CHUTE
CONTROL
KNOB
DRIVE SPEED
CON TROL LEVER
AUGER
CONTROL
LEVER
LIGHT
FUEL SHUT-OFF VALVE
ON / OFF
SWITCH
MUF FLER
GAS O LINE
FILLER CAP
SAFETY
IGNITION
KEY
CHOKE
CON-
TROL
PRIM ER
RECOIL (AUXILIARY) STARTER HANDLE
ELECTRIC
START
BUTTON
POWER
CORD
PLUG