Filter
Top Products
5
3
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY (See Fig. 3)
NOTE: For ease of assembly, you may wish to obtain the
as sis tance of another person for mounting cover assembly
to tractor.
1. Position cover assembly on ground behind tractor.
2. Lift and rotate cover to align cover brackets with support
assembly tubes.
3. Slide cover assembly down onto the support tubes.
FIG. 3
03024
COVER
ASSEMBLY
SUPPORT
ASSEMBLY
ASSEMBLY
02543
HANG SUPPORT ASSEMBLY ON
REAR DRAWBAR (See Fig. 2)
Determine the correct support assembly for your tractor.
The support assemblies are marked "A" and "B".
Compare the drawbar illustrations below to the drawbar
located at the rear of your tractor.
Use the support assembly indicated for your tractor and
discard the other support assembly.
2
FIG. 2
INSERT
FLANGES
FIRST INTO
DRAWBAR
SLOTS
SUPPORT
ASSEMBLY
DRAWBAR SLOTS
(Drawbar "A" shown)
RETAINER
SPRING
PIN
0
2
0
51
0
2
0
5
1
INSTALL HIGH LIFT BAGGING BLADES
(See Fig. 1)
CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap
blade with heavy cloth.
NOTE: If you already have high lift bagging blades on your
mower, store the supplied blades in a safe place for future
use. Go on to step 2.
1. Raise mower to highest position to allow access to
blades.
2. Remove blade bolts by turning counterclockwise.
3. Install bagging blades supplied with stamped "THIS
SIDE UP" facing up towards mower, or, blades stamped
with "GRASS SIDE" facing down towards grass.
IMPORTANT: To ensure proper assembly, center hole in blade
must align with star pattern on mandrel assembly.
4. Install and tighten blade bolts securely (45-55 Ft. Lbs.
torque).
02544
HIGH LIFT
BAGGING
BLADE
BLADE BOLT
(SPECIAL)
MANDREL
ASSEMBLY
FIG. 1
STAR
PATTERN
1
020
51
DRAWBAR
PIN HOLE
1. Slide fl anges of support assembly into drawbar slots
fi rst, then, pivot backwards inserting pin into drawbar
pin hole.
2. Be sure support assembly is seated properly, then
secure with retainer spring.
DRAWBAR A
Use Support Assembly
Marked "A"
DRAWBAR B
Use Support Assembly
Marked "B"